Servopump

Operating cycles (ideal):

e.g.
4. Injection at 50 l/min and 150 bar for 4 seconds

1. at l/min and bar for seconds

2. at l/min and bar for seconds

3. at l/min and bar for seconds

4. at l/min and bar for seconds

5. at l/min and bar for seconds

6. at l/min and bar for seconds

7. at l/min and bar for seconds

8. at l/min and bar for seconds

9. at l/min and bar for seconds

Alternative:

worst case 1: max. pressure: bar at existing flow rate: l/min at time: s

worst case 2: max. flow rate: l/min at existing pressure: bar at time: s

average flow rate at total cycle: l/min
average pressure at total cycle: bar
typical cylce time at the complete machine: seconds

Number of pumps:

1  2  not defined

Field bus:

EtherCAT  CANopen Sercos II  Profibus  CANsync 

Signal pressure set point:

voltage sensor  current sensor (voltage signal 0... 10V - external signal converter required)
field bus

Signal flow rate set point:

voltage sensor  current sensor (voltage signal 0... 10V - external signal converter required)
field bus

Signal pressure actual value (analog):

voltage sensor  current sensor (voltage signal 0... 10V - external signal converter required)

Types of cooling - converter:

standard cooling air
standard cooling water
push-through cooling air
push-through cooling water 
Cold Plate

Types of cooling - motor

not ventilated   water cooling   air cooling

Installation position motor:

horizontal  vertical

Other operating conditions:

storage fill-up  clear extruder screw    prehead oil 

Notes:

Company

Name

Department

Street, No

Country

Code City

Phone

Fax

E-Mail